Dear All  

There is a Basic Line Module 6SL3130-1TE31-0AA0 which with 
the error F30052 EEPROM data error, fault value r0949 
shows 0. 

The instructions say to replace the power module or update
 the EEPROM. 
Inside the power module in the block with the CPU there are 
two memory 24C16W-EEPROM and 25P80V-Serial Flash Memory. 

If 24C16W is an EEPROM, then it is readable and has data 
inside, but where can I download this EEPROM for flashing?

Hello,

every power unit has stored so called Power Stack Data inside.

And it is possible to download these datas again using special software. But it could be done only by Siemens authorized technician only.

Better contact your local Siemens service.

With regards

Martin

Downloading data to EEPROM is not a problem, it would be 
something to download

, but unfortunately there is no service in our country.

There was an EEPROM memory on the IGBT power board, and because

of the protective compound, i did not notice this, but after reading the

EEPROM, i was convinced that the data was correct.

The problem was on the CPU block itself, on the CPU board there was a

function to read EEPROMs in turn and therefore the EEPROM was not

read from the power board.

Hello sthefanizambrano992,

Please try to discuss your question in English language. This is an international community, and we try to focus on one language. Posting in English will help you to get more response to your question.

This is the translation of your question:

sthefanizambrano992

Good afternoon, were you able to solve the problem as I am having the same problem on a G-120 drive.

 Regards,
Jen_Moderator