SiePortal

The integrated platform for your product selection, buying and support workflow - bringing together Industry Mall and Online Support.

Products & Services
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
Support Support
{{(apiData.Support | filter:{'rank':1}:true)[0].title}} Support
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
MySiePortal MySiePortal
{{(apiData.MySiePortal | filter:{'rank':1}:true)[0].title}} MySiePortal
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
Cart ({{apiData.CartCount}})

Navigation

Control Unit Selection in Sizer

11/3/2011 10:29 AM	Rate (0)
Rahul Sayre Experienced Member Joined: 2/24/2009 Last visit: 9/5/2025 Posts: 116 Rating: (2)	Dear Expert, I am configuring one project in Sizer for proper selection of Drive for (1FK7022-5AK71-0DA0). I am not able to select control unit. How to select control unit in sizer. Please guide me. regards, Rahul

Suggestion To thank Quote Answer

11/3/2011 11:39 AM	Rate (0)
JensS Posts: 739 Rating: (55)	dear Rahul Sayre for 1FK7 is synchronous motor you need an SINAMICS S120. few ways of selection possible. 1. start with net data – power data – drive data – motor data 2. select your motor, after that select the drive (incl. option) 3. selecting an application (it’s a bit complicated)
JensS Posts: 739 Rating: (55)
Suggestion To thank Quote Answer

11/4/2011 5:05 AM	Rate (0)
Rahul Sayre Experienced Member Joined: 2/24/2009 Last visit: 9/5/2025 Posts: 116 Rating: (2)	Dear Jens S, I have selected power module thats ok but from where I will able to select control unit supported by this power module. I am not getting tab for selecting control unit.I am not getting Assign component button. In Control unit selection we have to select performance card. Where I can get this tab. regards, Rahul

Suggestion To thank Quote Answer

11/4/2011 8:15 AM	Rate (0)
JensS Posts: 739 Rating: (55)	Hi Rahul, you need two select what it’s needed for: 1 axis (S110 & CU305) or x axis (S120). For x axis you need to select the control performance and further more. Please have a look into the catalogues, there you will find short system information: S110 = PM22: http://intranet.automation.siemens.com/mcms/infocenter/content/en/Pages/order_form.aspx?nodeKey=key_9175377 S120 = PM21: http://intranet.automation.siemens.com/mcms/infocenter/content/en/Pages/order_form.aspx?nodeKey=key_9174327 If you need deeper technical details, please contact your local Siemens or the technical support online-support.industry@siemens.com
JensS Posts: 739 Rating: (55)
Suggestion To thank Quote Answer

11/4/2011 1:35 PM	Rate (0)
Drives_Coach Posts: 133 Rating: (13)	For a typical S120 project in SIZER go to the closed loop control page and then open up the control type drop down list for a list of available control units. see attached screen shot Attachment screen shot.jpg (197 Downloads)
Drives_Coach Posts: 133 Rating: (13)
Suggestion To thank Quote Answer

Share this page:

Share this page on...