Dear all 

i want to split timer BCD value in MIN_SEC_MS

Means

HR:-  ADDRESS1

MIN:- ADDRESS2

SEC:-ADDRESS3

MS:- ADDRESS4

how can i do this??

hi,

what do you mean exactly?

do you mean S5-Timer?

you can try to mask the relevant BCD-digit to read the value.

Or you use the FC33 from IEC function blocks, S5TI_TIM. It converts the S5-time to datatype Time. It is the time in milliseconds like an integer. then you can easily calculate the seconds and minutes.

hope this helps,

regards,

mopS04

hi,

what do you mean exactly?

do you mean S5-Timer?

you can try to mask the relevant BCD-digit to read the value.

Or you use the FC33 from IEC function blocks, S5TI_TIM. It converts the S5-time to datatype Time. It is the time in milliseconds like an integer. then you can easily calculate the seconds and minutes.

hope this helps,

regards,

I am using step-7 v5.5,  i have TON timer and i want to show remaining time on scada how can i do this??

i attach 

Hi,

I think you mean these FAQ for TIA.

How, in WinCC (TIA Portal), do you specify the duration for a timer via an operator panel, and how do you output the remaining time?

 I don´t know this FB50 but I think it´s  possible to "adjust" this for V5.5 ?!

Regards,

Towome

Hi again,

check Screenshot...

Regards

Hi,

its depend on the value of timer, if it's equal or less than 1m , u can do as in the picture

 Regards

H.SAPER

If your requested time more you can use this ..

 Hello H.SAPER

Thanks for support, its working very fine.