Navigation
Rating 
Thanks 0
3 Entries
| 4/15/2019 3:40 PM | |
|
Posts: 108 Rating:
|
Hi. I can't change the MM_ENC_COMP_MAX_POINTS in 802D SL & 828D SL. What's the problem? thanks a lot. |
| 4/15/2019 6:14 PM | |
Joined: 4/28/2015 Last visit: 1/20/2026 Posts: 387 Rating:
|
Hi Tyamad, What value are you increasing from and to? Does the control report an alarm when you try and perform the increase? Sufficient NC user Memory is required else alarm 6000 will be reported following an NCK reset Please see page 435 of the attached parameter list manual https://support.industry.siemens.com/cs/ww/it/view/48018300/en ...sent from App Attachment828D_LH1_1110_en.pdf (110 Downloads) |
Last edited by: Jen_Moderator at: 4/16/2019 10:40:48 AMOptimized link and added PDF as an attachment. |
|
| 4/15/2019 8:36 PM | |
|
Posts: 108 Rating:
|
Hi. The controller doesn't permit to change MD38000 at all. Perhaps the parameter is read-only. thanks a lot.
|
Follow us on