MahmoudAshour

Dear alli have a problem in communication and data transfer with system Cpu 313C 2DP connected profi bus with ET200s Interface module have two digital inputs modules 6ES7 131-4BF00-0AA0 and eight Direct starters 3RK1301-0CB10-0AB4Case : after download the HWC the CPU going in run mode ,,, with SF and BFdue to the ET200s interface module in SFand BF flashing leds , PM-E in SF ,PM-D in SFand DS1x HF in SF all Red LEDS Are Blinkingso there's any paramter must be assigned in IM or PM or DS in HW Configuration ?image of system is attached 4 leds behaviourthanks for interestM.Ashour

MahmoudAshour

Dear all
i have a problem in communication and data transfer with system Cpu 313C 2DP connected profi bus with ET200s Interface module have two digital inputs modules 6ES7 131-4BF00-0AA0 and eight Direct starters 3RK1301-0CB10-0AB4
Case : after download the HWC the CPU going in run mode ,,, with SF and BF
due to the ET200s interface module in SFand BF flashing leds , PM-E in SF ,PM-D in SFand DS1x HF in SF all Red LEDS Are Blinking
so there's any paramter must be assigned in IM or PM or DS in HW Configuration ?
image of system is attached 4 leds behaviour

thanks for interest
M.Ashour

miami

Pranav J. Bhagat

The common error for not communicating may be assignment of device name. .

Only PROFINET devices must be assigned a name, PROFIBUS slaves always use there address.And on the picture is a PROFIBUS line.For me it looks like the PROFIBUS is not running correctly.Check the adresses (in HW Config and the DIP settings), the switches in the connectors, etcCall module diagnostics in HW Config and select the ET200 station

Ste39

Hi MahmoudAshour,
have you tried using the hardware diagnostics?
and send us your hardware configuration.

manmeet

Hi

Please refer to page 37 ofTHISmanual. It gives you the meaning of various LED combination.

As per this manual "The interface module is not configured or isconfigured incorrectly. No data exchange is taking place between the DP master and the interface module".

So check whether the profibus address of IM (DIP switch) is same as that of hardware configuration.

Regards

Manmeet

miami

Pranav J. Bhagat

The common error for not communicating may be assignment of device name. .

Only PROFINET devices must be assigned a name, PROFIBUS slaves always use there address.
And on the picture is a PROFIBUS line.

For me it looks like the PROFIBUS is not running correctly.
Check the adresses (in HW Config and the DIP settings), the switches in the connectors, etc
Call module diagnostics in HW Config and select the ET200 station

i tried to check the addresses and change it many times in DIP Switches Physical and in HW Configuration and redwonload but the resuslt was the same,,, and the same in bus connector switches make it ONand OFF depends on the node loacation in network
the nodes is show rightly in Accessible nodes for CPU and Two IMswith assigned addresses

So, i doubt in some paramters should be assigned in HW like DP interupt and Operation at preset<> Actual Configuration and may be somthings else
u will found Screen Shot for HWC Diagnose and ET200