I'm using an ET200sp with F-DI, and in all cabinets where I have a light base unit with the F-DI the input signals are not showing. F-DI (6ES7136-6BA00-0CA0) with 6ES7193-6BP00-0DA0 base unit.

There is no errors shown..

Hello,

I'm using an ET200sp with F-DI, and in all cabinets where I have a light base unit with the F-DI the input signals are not showing. F-DI (6ES7136-6BA00-0CA0) with 6ES7193-6BP00-0DA0 base unit.

There is no errors shown

PWR LED is glowing or not?

Input signals are not showing means, FDI module is not detecting sensor output  or the LED status for channels are not glowing?

Can post the device configuration screen shot? the sensors are 1001 evaluation or 1002 evaluation.

Have you assigned the fail-safe address to each F module?

you need to use the addresses  of FDI module in program to see the status in either program or Watch table that its true or false.

pdcolaco

I'm using an ET200sp with F-DI, and in all cabinets where I have a light base unit with the F-DI the input signals are not showing. F-DI (6ES7136-6BA00-0CA0) with 6ES7193-6BP00-0DA0 base unit.

There is no errors shown..

 hi pdcolaco,

what do you meand with "not showing"

where do you look at the F-DI´s?

Are they used in the F-program?

Why do they all have a ligth base unit? Do they all have an own power supply?

regards,

Hi! I have the same issue.

I'm using the safety card (Digital input module DI 8x24VDC - 6ES7 136-6BA00-0CA0). 

The input is a button 1oo2 equivalent. 150ms discrepancy time. 

I press the button and I receive the signal in the safety card but nothing in the program. 

I'm not overwriting inputs.

I swaped the wiring to other the next safety card and I have the same situation.

No errors in the ET200.

Any idea?

Hi,

are no signals shown in program, or do you check the signals only in a watch table/force table?

If you only monitor via watch/force table, the signals are only updated if the inputs are already used somewhere in the program.

regards

sancruz

Hi!

I'm using it in the program but it's not working. 

Alberte.Martinez

Hi!

I'm using it in the program but it's not working. 

Show us an online view of the ET200SP so we can see the status of it and the I/O area assigned to it. Then tell us where you have connected the sensors and show us a diagram of the connection. Then we would like to see a snap of the code where you are using the inputs, in online view.

ps. When you have 1oo2 configured for two safety channels, only the first channel will activate in the monitor view, and the second will not change status in monitor view.