Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

communicate s7-300 with sentron pac3200 via profibus

Created by: Waelsg at: 2/27/2014 10:12 PM (3 Replies)

Rating (0)

Thanks 2

4 Entries

2/27/2014 10:12 PM	Rate (0)
Waelsg Posts: 5 Rating: (0)	I want to recover energy values measured by SENTRON PAC3200 with a CPU 317-2 DP via Profibus, but I do not know how to access the output addresses of SENTRON PAC3200 and where I can find these addresses, I tried with the example WinCC powerrate but I have not come to understand
Waelsg Posts: 5 Rating: (0)
Suggestion To thank Quote Answer

2/27/2014 10:41 PM	Rate (0)
IBN-Service Posts: 8946 Rating: (999)	The adresses are defined in HW-Config as slave parameters.
IBN-Service Posts: 8946 Rating: (999)
Suggestion To thank Quote Answer

2/27/2014 11:22 PM	Rate (0)
Waelsg Posts: 5 Rating: (0)	for example i use the basic type 1 but i don't know where i can read the current L1,L2,L3 for example.i hope that you understand my problem
Waelsg Posts: 5 Rating: (0)
Suggestion To thank Quote Answer

3/3/2014 10:25 AM	Rate (0)
Ste39 Platinum Member Joined: 1/21/2013 Last visit: 10/23/2024 Posts: 4620 Rating: (708)	Hello Waelsg, take a look, go to chapter 5: PAC PROFIBUS DP, SWITCHED ETHERNET PROFINET - Siemens

Suggestion To thank Quote Answer
This contribution was helpful to 2 thankful Users IBN-Service Ugljesa

|

Share this page:

Share this page on...

Follow us on