Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

WinAC CPU416-2 DP ISA

Created by: AutoGen_313976 at: 4/9/2014 2:19 AM (2 Replies)

Rating (0)

Thanks 0

3 Entries

4/9/2014 2:19 AM	Rate (0)
AutoGen_313976 Posts: 5 Rating: (0)	Guys I Have a CPU416-2 DP ISA in an old machine, we want to migrate to a new CPU 300 PLC, what do you recommend? We use that PLC for a cutting fly project, with 3 drives (2 simoreg, 1 simovert) we only want to change the PLC because the CPU416 isnt available. Does Siemens have a direct replacement? Or should we re-do all the program for a new PLC? Almost all the programming is in SCL, and it have some blocks for the motion control of the flying shear Thanks!
AutoGen_313976 Posts: 5 Rating: (0)
Suggestion To thank Quote Answer

4/9/2014 1:47 PM	Rate (0)
Pakeki Regular Member Joined: 9/17/2013 Last visit: 2/28/2023 Posts: 20 Rating: (2)	Hi AutoGen, do you want to switch to a 300? Or use PC-Based again? regards Pakeki

Suggestion To thank Quote Answer

4/9/2014 5:19 PM	Rate (0)
AutoGen_313976 Posts: 5 Rating: (0)	The original plan was change it for a CPU300, but Im open for suggestions Is it posible to change for a CPU300? What PLC can manage for a motion control application? Or you suggest to still use the pc based plc? Thanks for the fast replay Greetings
AutoGen_313976 Posts: 5 Rating: (0)
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on