Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

Using 4-20mA powered from the field

Created by: DROOP at: 5/1/2007 10:18 PM (3 Replies)

Rating (0)

Thanks 0

4 Entries

5/1/2007 10:18 PM	Rate (0)
DROOP Posts: 18 Rating: (0)	Use a voltage measurement from DEIF in sivacon switchboard. This DEIF311DG gives a 4-20mA 24Vdc output. How can I connect this to an analog input 331-7KF02-0AB0.
DROOP Posts: 18 Rating: (0)
Suggestion To thank Quote Answer

5/2/2007 4:35 AM	Rate (0)
Dec Gold Member Joined: 5/19/2006 Last visit: 10/23/2024 Posts: 549 Rating: (107)	DROOP This DEIF311DG gives a 4-20mA 24Vdc output. How can I connect this to an analog input 331-7KF02-0AB0. If your sensor is "4/2 wire transducer" you modify the little square bridge(side of the card) on C/D position. Dec
	Last edited by: Dec at: 02.05.2007 04:36
Suggestion To thank Quote Answer

5/19/2014 5:36 PM	Rate (0)
@nkur Posts: 202 Rating: (16)	DROOP Use a voltage measurement from DEIF in sivacon switchboard. This DEIF311DG gives a 4-20mA 24Vdc output. How can I connect this to an analog input 331-7KF02-0AB0. Hi There Note the anlog module that you mentioned is config. to both 4-20mA & 0-10V DC,RTD Thermocouple.
@nkur Posts: 202 Rating: (16)
Suggestion To thank Quote Answer

5/20/2014 6:42 PM	Rate (0)
metwally mustafa Silver Member Joined: 10/10/2010 Last visit: 10/25/2024 Posts: 307 Rating: (15)	fro the DIP switch in the module and hardware configuration you can set the module for current measurments

Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on