Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

Siemens MP270

Created by: hdhosseini at: 9/12/2010 4:12 PM (2 Replies)

Rating (0)

Thanks 1

3 Entries

9/12/2010 4:12 PM	Rate (0)
hdhosseini Diamond Member Joined: 1/28/2009 Last visit: 12/17/2025 Posts: 6885 Rating: (1368)	Hi Is it possible to upload an editable project by PROTOOL from an MP270? I know a way tomakea total back of the panel but it is not editable. Best regards hdhosseini
	Demo Channel on Youtube
Suggestion To thank Quote Answer

9/12/2010 4:32 PM	Rate (0)
umencho Grandmaster-Expert Joined: 3/21/2006 Last visit: 10/16/2025 Posts: 10239 Rating: (1183)	Hello, To take a editable backup from MP270 is possible using Protool if the Transfer of the current project file from the configuration computer to the operating unit must be performed using the Upload option "Enable upload". Not editable backup is possible to take using Prosave software. This backup later is possible to restore only in the same type panel - MP270 in your case. Procedure for this, you could find here searching for "Prosave". Best regards, Hristo Mihalev

Suggestion To thank Quote Answer
This contribution was helpful to 1 thankful Users hdhosseini

2/15/2016 10:29 AM	Rate (0)
Min_Moderator Posts: 4758 Rating: (122)	New question published by Mikola90 is split to a separate thread with the subject Connect MP270B to CPU 416-3DP with ProTool. Best regards Min_Moderator
Min_Moderator Posts: 4758 Rating: (122)
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on