Hello,

I have 1FG1106-xZF13-2xP1-Z N32+D04 motor with break and encoder conected to single motor module, like it shown on the circuit diagram below:

I have break control function seted at [1]

If I try to enable Axis with operation control panel immediately i get error F07930(40) Drive: Brake control error.

Cable line and break checked. No Short cut. Break R=16.5 Ohm.

Also if I try to enable break with break control function [0]->[2]  it works properly, without errors.

With P1278 ->1 Also works without issue. 

Pls help in advise.