Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

Batt. indicator switch on the PS407 - what position should it be?

Created by: Ters1983 at: 2/11/2019 8:08 AM (3 Replies)

Rating (0)

Thanks 0

4 Entries

2/11/2019 8:08 AM	Rate (0)
Ters1983 Posts: 1 Rating: (0)	Good day Just want to know the Batt. indicator switch on the PS407 in what position should it be? I found the LED on as follow BAF (RED LED) and BATTF (Orange LED) on when switch is on. And on the line OP screens it says Battery PLC Empty How do i correct this after batt has been replaced? Regards Tertius ------------------------------------------------------------------------------------------ Split from BAF-FAULT IN PS407.
Ters1983 Posts: 1 Rating: (0)	Last edited by: Jen_Moderator at: 2/11/2019 2:10:03 PM New subject after splitting
Suggestion To thank Quote Answer

2/11/2019 5:38 PM	Rate (0)
dchartier Grandmaster-Expert Joined: 9/27/2006 Last visit: 11/16/2024 Posts: 12294 Rating: (2691)	Hello Tewrs; Originally, you attached your question to an older thread, where a manual was suggested. Did you think of opening the manual to see if it answered your question? S7-400, M7-400 Programmable Controllers Module Specifications https://support.industry.siemens.com/cs/ww/en/view/19539653 Hope this helps, Daniel Chartier Attachment BATF.jpg (745 Downloads)

Suggestion To thank Quote Answer

8/23/2023 12:31 PM	Rate (0)
AutoGen_5526497 Joined: 5/31/2023 Last visit: 8/23/2023 Posts: 1 Rating: (0)	what is the last opinion about the position of this switch during running , if it is on off position is this measns batterys are off not used ?

Suggestion To thank Quote Answer

8/26/2023 4:32 PM	Rate (0)
Ayman Elotaify Platinum Member Joined: 5/28/2008 Last visit: 11/6/2024 Posts: 4516 Rating: (839)	AutoGen_5526497 what is the last opinion about the position of this switch during running , if it is on off position is this measns batterys are off not used ? Hello, If you put Battery Switch to the off position, it means that you have deactivated the monitor / LED status of the battery status. So, it is highly recommended to keep it at ON position to keep monitoring the battery status. Hope this helps.
	Ayman Elotaify
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on