Issue with ERTEC 200P in Release Mode

Dear Siemens Support Team,

I am currently working with the ERTEC 200P and have encountered an issue. The system was functioning correctly in debug mode. However, when I built the code with release mode settings, the system hung and became unresponsive.

Could you please provide guidance on the following:

1. Are there any known issues or differences between debug and release mode that could cause this behavior?
2. What specific steps should I take to troubleshoot and resolve this issue?
3. Are there any recommended configurations or settings for the ERTEC 200P when building in release mode?
4. Could this issue be related to specific hardware or firmware versions?

Thank you for your assistance.

Hi manovikas_dm172,

This is a user-driven forum, and it would take a long time to get an answer to your very specific question. So I would suggest that you contact the appropriate support team at profinet.devkits.industry@siemens.com.

Kind regards
Stefan