LeoVel:

Compre reciente un PLC de seguridad código 6ES7214-1HF40-0XB0 y los módulos de entrada y salida de seguridad, códigos 6ES7226-6BA32-0XB0 y 6ES7226-6DA32-0XB0. El problema es radical en que el PLC no reconoce los módulos de seguridad, pero los módulos normales si los reconoce. Estoy utilizando el software recomendado por TOOL TIA V20 código 6ES7822-0AA24-0YA5.

Al parecer el firmware de los módulos de suguridad no van con el firmware del PLC.

Hello Leovelvar73$,

English is the desired language in this forum. Please be so kind and write your posts in English.
Thanks.

Translate to English: 

Leovelvar73$

LeoVel:

I recently purchased a safety PLC, code 6ES7214-1HF40-0XB0, and safety input and output modules, code 6ES7226-6BA32-0XB0 and 6ES7226-6DA32-0XB0. The fundamental problem is that the PLC doesn't recognize the safety modules, but it does recognize the regular modules. I'm using the software recommended by TOOL TIA V20, code 6ES7822-0AA24-0YA5.

It seems the firmware for the safety modules doesn't match the PLC firmware.

I understand, and thank you for the clarification about the language.

I have recently purchased a safety PLC, code 6ES7214-1HF40-0XB0, along with its safety input and output modules, codes 6ES7226-6BA32-0XB0 and 6ES7226-6DA32-0XB0. The problem I am experiencing is that the PLC does not recognize the safety modules presented here, and therefore does not allow the CPU to enter Run mode. 

Strangely, it does recognize the normal modules that are not safety-related. I am using the recommended software TOOL TIA V20, code 6ES7822-0AA24-0YA5.It seems that the firmware of the PLC or the safety modules is not compatible with the PLC firmware. 

Could someone recommend what I can do?