Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

FB for Micromaster420/440

Created by: multimeter at: 9/1/2006 12:41 PM (1 Replies)

Rating (0)

Thanks 0

2 Entries

9/1/2006 12:41 PM	Rate (0)
multimeter Advanced Member Joined: 8/31/2006 Last visit: 10/4/2024 Posts: 20 Rating: (0)	Hi All, I hope this is in the right posting. I have Drives ES and I am trying to configure an S7313-2DP PLC to set the drive parameters on a MICROMASTER 440. As far as I understand, a data block can do this, but I havent a scooby on how to do it. The drive is connectedvia Profibus to the PLC, but during time, if it needs replaced the PLC could set the Parameters in the new drive. thanks multimeter

Suggestion To thank Quote Answer

9/1/2006 6:26 PM	Rate (0)
Denilson Pegaia Platinum Member Joined: 9/23/2005 Last visit: 11/13/2024 Posts: 4352 Rating: (1452)	Hi, You will need a logic (e.g. a FB) to communicate with a drive. I suggest you see these two samples: MICROMASTER: Function block to operate on Profibus DP http://support.automation.siemens.com/WW/view/en/22318171 MICROMASTER: Function block (FC14) to control an MM4 via Profibus-DP http://support.automation.siemens.com/WW/view/en/22078757
	Denilson Pegaia Siemens Industry Sector Technical Support
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on