Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

Error code on diods. 315F-2 DP

Created by: dande74 at: 3/27/2007 5:21 PM (3 Replies)

Rating (0)

Thanks 0

4 Entries

3/27/2007 5:21 PM	Rate (0)
dande74 Bronze Member Joined: 2/5/2007 Last visit: 9/9/2023 Posts: 101 Rating: (10)	I have a CPU, 315F-2 DP,that went into stop when i disconnected the programming cable. Alla diods on the front flashed continously at the same time. What does that mean? -- Daniel
	Last edited by: dande74 at: 27.03.2007 17:22 Misspell in subject
Suggestion To thank Quote Answer

3/27/2007 5:26 PM	Rate (0)
miami Platinum Expert Joined: 8/31/2005 Last visit: 11/13/2024 Posts: 2198 Rating: (328)	I think the CPU is crashed, maybe some grounding problem or electrical noise. Try to readout the diagnistics buffer, it may give additional information.

Suggestion To thank Quote Answer

3/28/2007 7:01 AM	Rate (0)
Aret Posts: 2348 Rating: (264)	Actually you must turn off your PG BEFORE you disconnect programming cable. Then disconnect cable on PG side and only then disconnect it from CPU. That's most saftiest way. In other cases you may burn port on CPU (personally I had such expirience :^) )
Aret Posts: 2348 Rating: (264)
Suggestion To thank Quote Answer

3/28/2007 8:06 AM	Rate (0)
dande74 Bronze Member Joined: 2/5/2007 Last visit: 9/9/2023 Posts: 101 Rating: (10)	Ok, I understand. I Will considerthat in the future. Thanks. -- Daniel

Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on