Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

SIWAREX U - SF, ST1 and ST2 lights on

Created by: ClaPet at: 5/16/2007 10:33 AM (2 Replies)

Rating (0)

Thanks 0

3 Entries

5/16/2007 10:33 AM	Rate (0)
ClaPet Posts: 26 Rating: (0)	One of our customers has a Siwarex U module type 7MH4601-1BA01. The SF, ST1 and ST2 indications are permanently on. When they connect the load cell the 24V light comes on. Does this indicate that the module isfaulty? Best Regards ClaPet
ClaPet Posts: 26 Rating: (0)
Suggestion To thank Quote Answer

5/31/2007 2:03 AM	Rate (0)
Chook Experienced Member Joined: 6/13/2006 Last visit: 9/21/2023 Posts: 201 Rating: (8)	ClaPet One of our customers has a Siwarex U module type 7MH4601-1BA01. The SF, ST1 and ST2 indications are permanently on. When they connect the load cell the 24V light comes on. Does this indicate that the module isfaulty? Best Regards ClaPet Hell Clapet, After the power is turned on, the SIWAREX U switches to operation mode. If operating correctly, the LEDs below will indicate the following states: LED (24 V)--> ON status LED (SF)--> OFF status If the LEDs do not indicate the correct states (e.g., A/D converter, control level limit exceeded)., proceed as described in section 12 of manual. Regards, Chook
	[IMG]http://i17.tinypic.com/66b7jas.jpg[/IMG]
Suggestion To thank Quote Answer

7/10/2007 7:20 AM	Rate (0)
liang Member Joined: 3/2/2006 Last visit: 10/16/2021 Posts: 8 Rating: (0)	Hello, if the SIWAREX U SF light on, I think it is the problem of loadcell, maybe it is wrong wring or wiring is broken. Check the loadcell problem.

Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on