Hi Cork!

I did some seaching and found this older thread Link.

User "Techonology team" provides a good awnser I think.

corkscrew2

hii all,
I have a simple problem at motion axis (V8.0) configuration at a 1214cpu via tiaV17 .
We wanna use one of the two end stop switches as home sw. But I could not succeeded, because the system get end sw touch alarm. I configured the homing command mode with 3.  
How is it possible tou use one of the end limit sw as home sw without any alarm? Or is it possible?
I have two axis configured same way. One of the axis referenced with alarm but the other axis NEVER referenced and get stuck with alarm. Why I could not understand. What is the difference?
I am trying to control two 3rd party stepper controller via PTO at this project. I can use one of axis in a normal way without difficulty because it referenced . But the other one never referenced even touching the limit sw.

 Br