Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

Mobile panel 177-DP Error Message " Counld not establish connection!"

Created by: huynguyen90 at: 5/10/2022 4:37 AM (1 Replies)

Rating (0)

Thanks 0

2 Entries

5/10/2022 4:37 AM	Rate (0)
huynguyen90 Posts: 2 Rating: (0)	Hello All, I have used Wincc Flexible 2008 to backup/restore from Mobile panel 177-DP HMI. I have used RS232/PPI, USB/PPI, MPI/PPI cables to connect to the DP9 port on the back of the monitor but cannot connect between them. after connection failed i get 1 message below image. Please help me, show me how to connect them. Thanks. Attachment b358996a0ed8c08699c9.jpg (604 Downloads)
huynguyen90 Posts: 2 Rating: (0)
Suggestion To thank Quote Answer

5/10/2022 8:49 AM	Rate (0)
Wizard Diamond Expert Joined: 4/24/2006 Last visit: 11/6/2024 Posts: 8768 Rating: (1170)	Hello, You will have to use RS232/PPI multimaster cable. Here is a link with more information: How can you transfer a WinCC flexible project serially to a panel? Best regards, Wizard

Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on