Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

WinCC missing Transfer button

Created by: romrot at: 3/14/2023 7:27 PM (2 Replies)

Rating (0)

Thanks 1

3 Entries

3/14/2023 7:27 PM	Rate (0)
romrot Member Joined: 1/7/2022 Last visit: 10/30/2024 Posts: 5 Rating: (0)	I've looked at the other two posts about this issue, but neither of them had a solution that worked for me. Verison 2008 SP5 Upd2 on windows 10

Suggestion To thank Quote Answer

3/15/2023 12:08 PM	Rate (0)
itafusna Silver Member Joined: 2/17/2020 Last visit: 11/8/2024 Posts: 1112 Rating: (204)	Hi, Please try this: How can you reset WinCC flexible to the original status of the last installation?
	A rating will be well appreciated.
Suggestion To thank Quote Answer
This contribution was helpful to 1 thankful Users Murof

3/16/2023 10:14 AM	Rate (0)
Murof Platinum Expert Joined: 8/3/2009 Last visit: 11/8/2024 Posts: 14127 Rating: (1769)	Hello romrot It could also be that you have set not the latest available Version of your Panel in the Project. -> create an new panel -< can you then see the transfer button? Check on your panel -> rightklick on the Panel-> change device type -> check here the Verion of device (it its not done select the newest available Version) If this is not the point then the Reset in Startcenter as already mentioned will help you Bye Murof
	If this Information really helps, you could use the Rate function
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on