Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

MB_Client error

Created by: masoudnfd3111 at: 8/2/2024 1:14 PM (2 Replies)

Rating (0)

Thanks 1

3 Entries

8/2/2024 1:14 PM	Rate (0)
masoudnfd3111 Member Joined: 10/7/2019 Last visit: 11/2/2024 Posts: 2 Rating: (0)	Hello friends I have one S7 1500 plc and 8 S7 1200 plcs Plc 1500 is used as master and plc 1200 as slave I put two numbers of mb_server (read, write) for slaves and two numbers of MB_Client (read, write) for each slave. The connection_id of each block is also unique The request command of each MB_Client is activated with done or error of the previous MB_Client block. Everything is ok and the read and write operations are performed well, but if one of the slaves is disconnected and reconnected, the mb_clinet block corresponding to that slave(disconnected and reconnect) does not give done and keeps giving errors. If I factory reset the master (s7 1500) and program it again, the problem is solved and the read and write operations are performed successfully. How can I solve the problem without factory reset?

Suggestion To thank Quote Answer

8/5/2024 11:19 AM	Rate (0)
alanTI Member Joined: 7/5/2021 Last visit: 11/5/2024 Posts: 147 Rating: (14)	I have found that if local port and remote port are not fully configured in both the client and server, there is some buggy behavior in disconnecting and reconnecting.

Suggestion To thank Quote Answer
This contribution was helpful to 1 thankful Users danw

8/6/2024 9:44 AM	Rate (0)
Murof Platinum Member Joined: 8/3/2009 Last visit: 11/7/2024 Posts: 14112 Rating: (1767)	Hello masoudnfd3111 Check also the basic example for information: https://support.industry.siemens.com/cs/de/en/view/102020340 Bye Murof
	If this Information really helps, you could use the Rate function
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on