Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

Reg:CPU 1212C is not go to run mode

Created by: satz at: 2/24/2012 4:21 PM (2 Replies)

Rating (0)

Thanks 0

3 Entries

2/24/2012 4:21 PM	Rate (0)
satz Posts: 5 Rating: (0)	Dear Friends, I faced one problem in S7 1200 plc (CPU 1212C). Plc not go to run mode, herewith I have attached the diagnostic message for ref. Regards, satz. Attachment Diagnostics 1212C.zip (242 Downloads)
satz Posts: 5 Rating: (0)
Suggestion To thank Quote Answer

2/24/2012 5:00 PM	Rate (0)
0_Einstein Diamond Expert Joined: 7/7/2010 Last visit: 11/15/2024 Posts: 15402 Rating: (2445)	You will be better off to perform a "reset to factory defaults" (maintaining ip address). Then reload the project and it should go into start. Post your results!
	science guy
Suggestion To thank Quote Answer

2/25/2012 6:41 PM	Rate (0)
Ganes10 Platinum Member Joined: 8/31/2010 Last visit: 11/6/2024 Posts: 1523 Rating: (229)	Hello satz, Steps on "How to perform the Resetting to Factory Settings?"
	Like it? Rate it!
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on