Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

Base Program

Created by: audy at: 4/18/2007 7:59 PM (4 Replies)

Rating (1)

Thanks 0

5 Entries

4/18/2007 7:59 PM	Rate (0)
audy Posts: 71 Rating: (2)	Dear friends. what is the base program? how to open it? how to deal with? is it for downloading to NCU? I am using SINUMERIK 840D ( MILLING machine) thanks too much audy
audy Posts: 71 Rating: (2)
Suggestion To thank Quote Answer

4/19/2007 6:33 AM	Rate (0)
SteveJ Posts: 328 Rating: (29)	Dear Sir Plese give more information about your enquiry, where have you found this base program? In your control system? Or in 840D toolbox? Regards SteveJ
SteveJ Posts: 328 Rating: (29)
Suggestion To thank Quote Answer

4/19/2007 7:54 PM	Rate (0)
audy Posts: 71 Rating: (2)	Dear SteveJ, In 840D TOOLBOX CD. I hope more help thanks audy.
audy Posts: 71 Rating: (2)
Suggestion To thank Quote Answer

4/23/2007 3:06 AM	Rate (1)
SteveJ Posts: 328 Rating: (29)	Dear Sir The base program of which you enquire is a basic PLC program for 840D/810D, it contains blocks for S7 300 plc when intergrated into Sinumerik NCU / CCU. These blocks are required in many cases and are the basis for the machine tool PLC proram. It is installed on the programming device and is automatically integrated in Simatic manager (Libraries) It is refered to as the Grund program. Hope this is of some help. Best Regards SteveJ
SteveJ Posts: 328 Rating: (29)
Suggestion To thank Quote Answer

4/25/2007 5:17 PM	Rate (0)
audy Posts: 71 Rating: (2)	Dear SeveJ, thanks for your help, it actaul helps me. thanks for you interest. audy.
audy Posts: 71 Rating: (2)
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on