Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

@DU3 block

Created by: DUTTA at: 3/21/2008 3:58 PM (2 Replies)

Rating (0)

Thanks 0

3 Entries

3/21/2008 3:58 PM	Rate (0)
DUTTA Posts: 102 Rating: (1)	Dear Expert, I want to use Dust 3 protocol in PM16 processors. For that I have configured a sample program in STRUC L V4.2.7 In that project I configure master program with 1 PM16 processor, MS41, and two Serial Interface. In Master program configuratoin when I m trying to call @DU3 block I can not. It give me the message Name defination is defective. Can u tell me what should I do to call DUST 3 block? regards,
DUTTA Posts: 102 Rating: (1)
Suggestion To thank Quote Answer

3/26/2008 1:43 PM	Rate (0)
miami Platinum Expert Joined: 8/31/2005 Last visit: 11/13/2024 Posts: 2198 Rating: (330)	I'm not shure, because it changed from STRUC 3 to STRUC 4. But I think in STRUC 4 youhave to call the @DU3 in the FP-SEND (in a tasktime between 32 and 256 ms) In the masterprogram you only define the hardware. I
	Last edited by: miami at: 3/26/2008 1:45 PM
Suggestion To thank Quote Answer

3/26/2008 1:53 PM	Rate (0)
DUTTA Posts: 102 Rating: (1)	Dear Miami, Yes I have placed @DU3 block in SEND-FP and got successful complied my programe. thanx for the help regards,
DUTTA Posts: 102 Rating: (1)
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on