Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

0.375mA FUSE BLOW AT REPETITION

Created by: Simonccr at: 3/5/2014 6:50 PM (3 Replies)

Rating (0)

Thanks 0

4 Entries

3/5/2014 6:50 PM	Rate (0)
Simonccr Posts: 1 Rating: (0)	Hi, we began to change our old Milltronics by new version Siemens Multiranger 100. Sometimes all's good, but sometimes the fuse 0.375mA blow at repetition. Anybody have idea why? We have a lot of milltronics multiranger here... i'm a little bit afraid for our futur! Thanks Simon
Simonccr Posts: 1 Rating: (0)
Suggestion To thank Quote Answer

3/7/2014 1:05 AM	Rate (0)
danw Gold Expert Joined: 3/28/2010 Last visit: 12/7/2023 Posts: 987 Rating: (202)	The fuse is spec'd as a slow blow fuse. Is yours a slow blow? fuse: F3: 2 AG, Slow Blow, 0.375A, 250V

Suggestion To thank Quote Answer

3/26/2014 10:54 AM	Rate (0)
Levelmans Bronze Member Joined: 12/13/2012 Last visit: 10/5/2023 Posts: 124 Rating: (45)	Dear Simonccr , the 0,375A is the fuse of the ACpower supply. It´s very untypical that this fuse is blowing. For me this soundslike a effect because ofstress peaks ect. Do you only have ACversions of the Multiranger 100 in the field ? Best Regards Levelmans

Suggestion To thank Quote Answer

3/27/2014 10:36 PM	Rate (0)
Chook Experienced Member Joined: 6/13/2006 Last visit: 9/21/2023 Posts: 201 Rating: (8)	Simonccr Hi, we began to change our old Milltronics by new version Siemens Multiranger 100. Sometimes all's good, but sometimes the fuse 0.375mA blow at repetition. Anybody have idea why? We have a lot of milltronics multiranger here... i'm a little bit afraid for our futur! Thanks Simon Hi, This fuse onpower supplyis to protect the circuit board,there area few reasons when the fuse blew up as water damage,short circuit, over voltage. Regards chook
	[IMG]http://i17.tinypic.com/66b7jas.jpg[/IMG]
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on