Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

3RW55 soft starer: parameters aren't saved

Created by: AutoGen_4048341 at: 7/13/2023 7:12 AM (2 Replies)

Rating (0)

Thanks 0

3 Entries

7/13/2023 7:12 AM	Rate (0)
AutoGen_4048341 Joined: 2/9/2022 Last visit: 8/28/2024 Posts: 1 Rating: (0)	Good people, I am also using 3RW55 soft starer everytime after power failure I have to put in parameters, it looks like it in not saving them, please help. ------------------------------------------------------------------------------------------ Split from 3RW55: some of these drives are not saving the settings.
	Last edited by: Jen_Moderator at: 07/13/2023 11:10:44 New subject after splitting
Suggestion To thank Quote Answer

7/19/2023 8:17 AM	Rate (0)
Sirius_3 Advanced Expert Joined: 4/15/2009 Last visit: 10/23/2024 Posts: 128 Rating: (11)	Hello, you have probably not yet activated the parameter lock. I assume that the device was parameterized via the HMI or local PC? The parameter lock in this case prevents that during startup on the bus (e.g. when the control voltage is switched on), the default parameters that are stored in the CPU are automatically downloaded and the parameters that were changed via the HMI or local PC are overwritten again. Best regards Sirius_3

Suggestion To thank Quote Answer

10/24/2023 9:01 AM	Rate (0)
Jen_Moderator Diamond Member Joined: 6/19/2017 Last visit: 9/6/2024 Posts: 8175 Rating: (172)	New question published by vdjo@desmetballestra.com is split to a separate thread with the subject What is the procedure to "lock the parameters"?. Best regards Jen_Moderator

Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on