Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

6ra8031 6dv62: The BOP panel automatically gets off while running

Created by: Alibravo at: 9/13/2019 11:05 PM (2 Replies)

Rating (0)

Thanks 1

3 Entries

9/13/2019 11:05 PM	Rate (0)
Alibravo Member Joined: 9/11/2019 Last visit: 1/4/2023 Posts: 3 Rating: (0)	Hi, I am having a problem in my DC drive 6ra8031 6dv62. The BOP panel automatically gets off while running also sometimes dont get on when supplied with power. drive is brand new. kindly assist I would be grateful to you. ------------------------------------------------------------------------------------------ Split from manual SINAMICS 6RA8031-6DV62-0AA0.
	Last edited by: Jen_Moderator at: 09/16/2019 08:04:35 New subject after splitting
Suggestion To thank Quote Answer

9/14/2019 2:13 PM	Rate (0)
PISCEAN 2010 Diamond Member Joined: 4/23/2010 Last visit: 11/14/2024 Posts: 8092 Rating: (878)	Alibravo Hi, I am having a problem in my DC drive 6ra8031 6dv62. The BOP panel automatically gets off while running also sometimes dont get on when supplied with power. drive is brand new. kindly assist I would be grateful to you. Please check the flat ribben cable is fixed tightly at BOP rear face connector. If it is OK, I suggest you to contact your nearest Siemens suppoet center since it is new drive. HTH

Suggestion To thank Quote Answer

10/10/2019 9:44 PM	Rate (0)
Alibravo Member Joined: 9/11/2019 Last visit: 1/4/2023 Posts: 3 Rating: (0)	Thank you, for your help. I have replaced the power module as there was some problem in its rectifier circuit. And during on/off fault they some resistors in power unit cards rectifies circuit automatically got burned. now with new power module card its working ok

Suggestion To thank Quote Answer
This contribution was helpful to 1 thankful Users PISCEAN 2010

|

Share this page:

Share this page on...

Related topics by keywords:

SINAMICS_DCM

Follow us on