Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

802D SL

Created by: ŠΜS at: 12/30/2011 2:10 PM (3 Replies)

Rating (0)

Thanks 0

4 Entries

12/30/2011 2:10 PM	Rate (0)
ŠΜS Silver Member Joined: 6/7/2010 Last visit: 7/9/2024 Posts: 571 Rating: (37)	Dear All, I am Facing an typical problem in 802D SL Controller.This machine is an horizontal boring machine.Normelly all the axis moveing fine, but when we stop and move the axis again all of sudden the axis is not moving but reading in the axis varing ( Still no alarm ).Has any one over came this problem. Below is its Version. Software version 01.04.06.01 Hardwar version 03.02.00.00 Internal version 01.40.52.00 Bios version 00.00.03.03 HMI version 05.06.42.00
	Regards, ŠΜS
Suggestion To thank Quote Answer

1/9/2012 1:06 PM	Rate (0)
ŠΜS Silver Member Joined: 6/7/2010 Last visit: 7/9/2024 Posts: 571 Rating: (37)	Hello, Does any one have an idea????
	Regards, ŠΜS
Suggestion To thank Quote Answer

1/9/2012 2:28 PM	Rate (0)
pfuser Silver Member Joined: 9/18/2006 Last visit: 9/2/2024 Posts: 591 Rating: (64)	HI. What is the significance of status? Drive data r2 (ALM, X, Z, SP)?

Suggestion To thank Quote Answer

1/11/2012 3:10 AM	Rate (0)
ŠΜS Silver Member Joined: 6/7/2010 Last visit: 7/9/2024 Posts: 571 Rating: (37)	pfuser HI. What is the significance of status? Drive data r2 (ALM, X, Z, SP)? Pulse Enable, Controller enable is active for all axis Drives. I havent checked the Drive Date r2 .If problem comes Again i will check it. Is any more points to be checked.
	Regards, ŠΜS
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on