Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

802DSl tool management

Created by: OvidiuNastac at: 10/15/2010 8:35 AM (4 Replies)

Rating (0)

Thanks 0

5 Entries

10/15/2010 8:35 AM	Rate (0)
OvidiuNastac Silver Member Joined: 1/29/2008 Last visit: 7/26/2022 Posts: 419 Rating: (19)	Hi I must retrofit a milling machine with 802Dsl. The configuration of the machine doesn't allow loading the tool trough the spindle and it needs the magazine list on the HMI. It's another way to display the tool position in the magazine list besides the creation of a new screen? Thank you for the replay. Nit

Suggestion To thank Quote Answer

10/15/2010 11:10 AM	Rate (0)
RAM81 Silver Member Joined: 3/3/2008 Last visit: 2/20/2023 Posts: 333 Rating: (51)	hi try to enabe .MD 332=1 this will display the tool number position in the tool list area. with regards ram

Suggestion To thank Quote Answer

10/16/2010 7:01 AM	Rate (0)
OvidiuNastac Silver Member Joined: 1/29/2008 Last visit: 7/26/2022 Posts: 419 Rating: (19)	Hi Thank you for the tip but where are stored the magazine tool data that will be displayed in that fields? Nit
	Last edited by: Nit at: 10/16/2010 7:07 AM
Suggestion To thank Quote Answer

4/19/2012 7:27 AM	Rate (0)
ncservis Advanced Member Joined: 11/9/2011 Last visit: 5/24/2023 Posts: 1 Rating: (0)	Nit Hi Thank you for the tip but where are stored the magazine tool data that will be displayed in that fields? Nit Hello, I have the same question. I have a 802dsl pro.

Suggestion To thank Quote Answer

5/14/2012 11:00 AM	Rate (0)
RAM81 Silver Member Joined: 3/3/2008 Last visit: 2/20/2023 Posts: 333 Rating: (51)	hi check out the variable $TC_DP25 with regards ram

Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on