810M GA3 message QVZ durch parity uberwachung.

Good day,

Battery went empty on my 810M GA3 and parameters erased.

After some time when I came back to the machine I saw the message QVZ durch parity uberwachung.

What could be the reason?

I cant get it to upload the parameters with eye button.

Photo in the attachment.

Any help would be appreciated.

Thank you.

------------------------------------------------------------------------------------------
Split from 810ME second RS 232C interface .

After removing the battery, and restart while holding Eye buton I am stuck on initializing screen.

All LED on the right of the screen are ON

Any help???

Hi,

Your QVZ error is a hardware error relating to I/O communication.

It looks like a hardware error. Disconnect the I/O cable and try again but I think you have a board fault.

Pee

Pee El Sea

Hi,

Your QVZ error is a hardware error relating to I/O communication.

It looks like a hardware error. Disconnect the I/O cable and try again but I think you have a board fault.

Pee

 Hy, and thank you for your support.

Which one is the I/O cable? Is this cable on the interface card?

I also believe that there is some hardware error, just not sure what could it be?

I have reload parameteres numerous times when battery went dead, but something else is wrong this time because I cant get pass initialize screen.

Is it card with CPU? RED LED on the back of the card is lit all the time.

Could it be EPROM error? 

Thank you.

nulizhang

Battery must be insert —try disconnecting 50 pin cable connection from the Interface module to see

and next can take out the measuring cards (analog output and encoders feedback) 

Hy, and thank you for your support.

Ok, I will insert the battery, disconnect the cable and then turn on the machine?

If this doesnt help, then I can remove the measuring cards and try if it works?

Is it normal that the RED LED on the back of the CPU card is lit all the time?

Could it be EPROM error?

Thank you.