Analog output 4-20mA instead of 0-10v which is linked with the Pin14

Hello 

I want to have Analog output 4-20mA instead of 0-10v which is linked with the Pin14, then I want know which Pin gives the value 4-20mA in the Serial Interface Module and  what we have to change the channel in the Fb251 block? Or is it the same?

thank you in advance.

------------------------------------------------------------------------------------------
Split from S5 95U analog output value.

MedRamy

Hello 

I want to have Analog output 4-20mA instead of 0-10v which is linked with the Pin14, then I want know which Pin gives the value 4-20mA in the Serial Interface Module and  what we have to change the channel in the Fb251 block? Or is it the same?

thank you in advance.

 Hello,

have a look at page 3-23 Figure 3-23 in above document, Pin 10 is QI 0..20 mA

THNX

so i want know what i have to chage in the program?

Segment 8 Instruction List:
SPA FB 251
NAME: RLG:AA
XE  : MW 12
BG  : KF +8
KNKT: KY 0,0
OGR : KF +1000
UGR : KF +0
FEH : M 2.1
BU  : M 2.2
***

i didn't find QW40 to change it 

sorry i don't know well about S5

Hello,

with FB251 (see pag.12-10) you dont write QW address but only slot number,

BG  : KF +8 means onboard output.

so you only have to change terminal,

pag.3.23 says:

manual pag.3-23

Depending on the terminal assignment, the analog output is either a "current" output or a "voltage" output.

Hope this helps.

Best Regards 

thank you 

I wanted to force the QW assignment, but I did not find it in the program

Where can I find it?

thank you in advance