Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

call fc write in scl on program cycle (in scl language)

Created by: boazeventall at: 5/24/2012 10:36 AM (2 Replies)

Rating (2)

Thanks 0

3 Entries

5/24/2012 10:36 AM	Rate (1)
boazeventall Posts: 131 Rating: (4)	i have created fc(writen in scl) and i want to call him from the ob did i called correct? or i have mistake. see at the picture Attachment ex.JPG (400 Downloads)
boazeventall Posts: 131 Rating: (4)
Suggestion To thank Quote Answer

5/24/2012 10:53 AM	Rate (1)
yy1 Gold Member Joined: 3/24/2009 Last visit: 1/5/2023 Posts: 535 Rating: (110)	Dear boazeventall, assuming, that your FC has no parameters in its interface, the code is correct! Best regards, yy1

Suggestion To thank Quote Answer

5/29/2012 3:17 PM	Rate (0)
0_Einstein Diamond Expert Joined: 7/7/2010 Last visit: 3/23/2023 Posts: 13203 Rating: (2147)	boazeventall i have created fc(writen in scl) and i want to call him from the ob did i called correct? or i have mistake. see at the picture The way I 'call' FCs & FBs is (from project view like your picture shows): 1. Select the FB/FC (left click) 2. Drag the selected FB/FC to the place in the code I want to call the FB/FC. Drag & Drop works great and fixes many problems. It also allocates parameters as well just like a built-in function block does when you drag it into the open block. If your calling ob compiles successfully, it is called correctly is another answer. The portal software has many ways or approaches to get the answers we seek.
	science guy
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on