Can't run sinamics g120 over terminal control ???

I can't run sinamics g120 over terminal control. I set p0015=12. I wired everything like instructed in manual. Sinamics should run in constant speed. I can't access parameter p700.  

Can anyone help me ?

Hello Daka,

which control unit are you using, a CU240-2? P15 = 12 means analogue setpoint, i.e. no fixed setpoint rather an analogue setpoint via AI0. Macro for fixed speed setpoint should be 2 or 4.

However, you should be able to turn on the drive with DI0. Can you check if P722.0 becomes true if you switch the 24V on?

i'm using CU240-2. In the parameter list I should find p722.0 ? How can I read it's actual value (true or false) ?

I can't even turn sinamics on in hand mode. Fan starts and nothing else. I have a little 'x' on my screen. 

I pass through quick commissioning, and successfully saved it.

New question published by g15 is split to a separate thread with the subject Drive power off, p0010 becomes 1.

Best regards
Min_Moderator

New question published by Humam-Yemen is split to a separate thread with the subject G120 driver do not run.

Best regards
Min_Moderator