Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

Cannot create a session for the project

Created by: seaaide at: 12/9/2009 2:57 PM (3 Replies)

Rating (0)

Thanks 0

4 Entries

12/9/2009 2:57 PM	Rate (0)
seaaide Posts: 6 Rating: (0)	Hi all, afteri run the project file, the attached dialog will be shown when openning database project. now how to fixed this trouble? thanks all B R seaaide Attachment Snap4.jpg (82 Downloads)
seaaide Posts: 6 Rating: (0)
Suggestion To thank Quote Answer

12/9/2009 3:55 PM	Rate (0)
The Brain Gold Member Joined: 10/19/2005 Last visit: 11/30/2020 Posts: 1611 Rating: (121)	Hi, did you get this message by all project which you try to open? Did you get also the message if you create a new project? Did you have make a software update? Which flexible Version did you use? I did not see this message before. regards,

Suggestion To thank Quote Answer

12/9/2009 7:27 PM	Rate (0)
seaaide Posts: 6 Rating: (0)	sorry this project was created by wincc flexible 2007. and my software is normally, this problem is only for this project. then i try to open it by version 2008 in another PC, but the dialog will be shown again.
seaaide Posts: 6 Rating: (0)	Last edited by: seaaide at: 12/9/2009 7:28 PM
Suggestion To thank Quote Answer

12/10/2009 8:57 AM	Rate (0)
The Brain Gold Member Joined: 10/19/2005 Last visit: 11/30/2020 Posts: 1611 Rating: (121)	Hi, i think that you should contact the Siemens hotline and sendthem the project. It shows, that the project are damaged. regards,

Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on