Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

Converting Wincc Flexible 2008 SP2 to Wincc Flexible 2008 SP3

Created by: Juanfer ICT at: 11/13/2017 1:04 PM (4 Replies)

Rating (2)

Thanks 3

5 Entries

11/13/2017 1:04 PM	Rate (0)
Juanfer ICT Posts: 3 Rating: (0)	Hello friends: I am working with a Panel PC "PC 477 15" Touch" and I have to update it. The problem is that I write below: The panel pc is programmed with "Wincc Flexible 2008 SP2" but on my PG I have to installed the "Wincc Flexible 2008 SP3". The file that I currently have is done with SP2, then when I go to open the file the software tell my if I want to convert to SP3, for this, the question is the next: If I press to the "yes button" and I work with the new file on SP3 and after I go to download the Panel, Will I have problems with the panel? or Can I to convert the file SP2 to SP3 and after donwload to de panel pc without problems? If someone could to help me I would thank him/her. Thank you!!!!
Juanfer ICT Posts: 3 Rating: (0)
Suggestion To thank Quote Answer

11/13/2017 2:56 PM	Rate (1)
Technology Team Platinum Member Joined: 10/11/2006 Last visit: 11/14/2024 Posts: 5941 Rating: (816)	Hello, normally it should work after upgrading. But it depends on your Operating System on your panel PC. With newer version it could be possible to upgrade the OS. With WinC flexible a setup for upgrading is also on the DVD.
	With best regards, Technology Team Application consulting and pre sales support for SINAMICS, SIMATIC Technology, SIMOTION, SIMOTICS and MOTION CONNECT
Suggestion To thank Quote Answer
This contribution was helpful to 1 thankful Users Juanfer ICT

11/14/2017 11:48 AM	Rate (0)
Towome Platinum Member Joined: 7/9/2015 Last visit: 11/15/2024 Posts: 4027 Rating: (603)	Hi, If you do not get a problem, you can not answer but in principle it should work. Regards, Towome
	If my post was useful, please rate me - if not, please tell me - thank you!
Suggestion To thank Quote Answer
This contribution was helpful to 1 thankful Users Juanfer ICT

11/14/2017 12:14 PM	Rate (1)
Wizard Diamond Expert Joined: 4/24/2006 Last visit: 11/15/2024 Posts: 8768 Rating: (1171)	Hello Juanfer ICT, If I understand it right: You have an Engineering PC (WinCC Flexible 2008 SP3) And a Panel PC (WinCC flexible 2008 SP2) (Runtime) Please have in mind: When you change the project in WinCC flexible 2008 sp3, you should use WinCC flexible 2008 Sp3 Runtime. So you will have to check if the Operating System on Panel PC, can work with WinCC flexible 2008 sp3 Runtime. Best regards, Wizard

Suggestion To thank Quote Answer
This contribution was helpful to 1 thankful Users Juanfer ICT

2/13/2023 10:06 AM	Rate (0)
Jen_Moderator Diamond Member Joined: 6/19/2017 Last visit: 9/6/2024 Posts: 8175 Rating: (172)	New question published by PiedraRoja is split to a separate thread with the subject Problem with the migration from wincc 2008 to tia portal 11. Best regards Jen_Moderator

Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on