Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

CP 1623 driver Problem

Created by: Niranjan Prasad at: 6/17/2010 8:04 PM (6 Replies)

Rating (0)

Thanks 1

7 Entries

6/17/2010 8:04 PM	Rate (0)
Niranjan Prasad Posts: 691 Rating: (37)	Dear All I am facing a great problem with CP 1623 Driver. I installed the Driver for CP1623 and I was able to change the IP Address of the CP 1623 But when I restarted the PC , I was not able to see the Network Connection Icon for CP1623.Also in the Device drivers , There was yellow mark on the Hardware ( CP 1623 Softbus miniport). For each time, when i am restarting the PC , I have to install the once again. I don't know what is the problem. Please Guide me
Niranjan Prasad Posts: 691 Rating: (37)
Suggestion To thank Quote Answer

6/17/2010 9:42 PM	Rate (0)
UMENCHO Diamond Member Joined: 3/21/2006 Last visit: 12/2/2024 Posts: 10229 Rating: (1181)	Hello, What kind OS do you have on the PC? Is this a fresh installation of OS or old one? Best regards, Hristo Mihalev

Suggestion To thank Quote Answer

6/18/2010 3:54 AM	Rate (0)
Niranjan Prasad Posts: 691 Rating: (37)	Its Fresh Windows XP Sp3 with PCS7 V7.1
Niranjan Prasad Posts: 691 Rating: (37)
Suggestion To thank Quote Answer

6/18/2010 8:04 AM	Rate (0)
UMENCHO Diamond Member Joined: 3/21/2006 Last visit: 12/2/2024 Posts: 10229 Rating: (1181)	Hello, If you already did all settings according to http://support.automation.siemens.com/WW/view/en/37173023 then could be problem with Windows OS. Best regards, Hristo Mihalev
	Last edited by: O_Moderator at: 8/25/2011 8:40 AM link edited
Suggestion To thank Quote Answer

6/18/2010 10:14 AM	Rate (0)
Krish Silver Member Joined: 5/24/2007 Last visit: 4/24/2024 Posts: 284 Rating: (27)	Hi Fade UP Try installing the Simatic Net Ver 7.1 SP2 Hotfix 1. (contact Siemens support) for this. There is a problem with the PG/PCInterfaceand Simatic Net which blocks connection to the CP Card in Simatic Net Ver 7.1 and so recently the Hotfix was made available. Krish

Suggestion To thank Quote Answer
This contribution was helpful to 1 thankful Users J_Bell

6/21/2010 2:22 PM	Rate (0)
Yolov Bronze Member Joined: 2/22/2006 Last visit: 12/17/2024 Posts: 291 Rating: (37)	Hi, Just an idea. Is it possible that you can not change IP address because the CP1623 is in Configured Mode - from Configuration Console? Regards

Suggestion To thank Quote Answer

7/15/2010 5:12 PM	Rate (0)
Niranjan Prasad Posts: 691 Rating: (37)	I got the problem in two HP Server PC because of which I am not able to access the Servers , not able to ping( but i am able communicate wincc through the onboard LAN Port) and also I am not able to change the NDIS IP Address Please help me out for configuring the NDIS IP Address and other problems Thanx
Niranjan Prasad Posts: 691 Rating: (37)
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on