CUA31-32 for PM240-2

I suppose the CUA31 and CUA32 are only suited for PM340.
Is there any possibility that they will also be released for PM240-2 in the future?

Jeff Casagrande

As far as I know, the CUA31-32 works with the PM 240-2 right now if your SINAMICS FW is 4.7.  The PM340 is on its way to being phased out, at least in frame size A-C.

 Thanks for your answer.
I tried to find this also in manual or some document of Siemens, but did not find this.
Is there somebody who has actualy used CUA31-32 on PM240-2, or can someone of Siemens confirm this?

I have not seen an "official" document however....

SIZER lets me select it.

SCOUT TIA lets me configure it with no compile errors.  See attached Test drive.

New question published by KPY007 is split to a separate thread with the subject Limitations having a D425-2 as the Simotion controller with appropriate safety licenses .

Best regards
CS Moderator