Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

DB symbol Name and Comments not shown in program

Created by: Dipsw at: 3/14/2012 10:44 AM (6 Replies)

Rating (1)

Thanks 2

7 Entries

3/14/2012 10:44 AM	Rate (0)
Dipsw Posts: 32 Rating: (0)	DB symbol Name and Comments not shown in program find attachment of program. Attachment DBCommentsproblem.zip (85 Downloads)
Dipsw Posts: 32 Rating: (0)
Suggestion To thank Quote Answer

3/14/2012 10:53 AM	Rate (0)
Darius Platinum Member Joined: 9/28/2005 Last visit: 11/5/2024 Posts: 2957 Rating: (242)	Hi, It seems that it is uploaded blocks from PLC. Symbol information is not stored in PLC so if you upload it you will not see any symbols.
	Best regards, Darius
Suggestion To thank Quote Answer

3/14/2012 11:00 AM	Rate (0)
Dipsw Posts: 32 Rating: (0)	Yes this is uploaded program but when comments and symbol name modifiled in DB specificly DB1 then why any comments shown in program like FC 1 etc. IN DB1 Flow_set_1WORDW#16#0Flow setpoint line 1 Sh3 FC1 no comments shown with symbol information.
Dipsw Posts: 32 Rating: (0)
Suggestion To thank Quote Answer

3/14/2012 11:09 AM	Rate (0)
UMENCHO Diamond Member Joined: 3/21/2006 Last visit: 11/1/2024 Posts: 10229 Rating: (1181)	Hello, From where did you get existing symbol table? You can see only these names which are exist in symbol table. Unfortunately to rename contents of DBs and temp variable, symbol table is not useful. Best regards, Hristo Mihalev

Suggestion To thank Quote Answer

3/14/2012 11:18 AM	Rate (0)
Dipsw Posts: 32 Rating: (0)	Existing symbol table is created by each input output symbol information additing but in DB (check DB1)when comments inserted in db no information shown when call in any program like fc (check FC 1).
Dipsw Posts: 32 Rating: (0)
Suggestion To thank Quote Answer

3/14/2012 11:21 AM	Rate (1)
UMENCHO Diamond Member Joined: 3/21/2006 Last visit: 11/1/2024 Posts: 10229 Rating: (1181)	Sorry I undrestood your point. Give a name to that DB. Then it will show you the symbols. Best regards, Hristo Mihalev

Suggestion To thank Quote Answer
This contribution was helpful to 1 thankful Users ibrahim454

3/14/2012 12:03 PM	Rate (0)
Dipsw Posts: 32 Rating: (0)	Thank you very very much for solving my problem which help me in my project. Regards, Dip
Dipsw Posts: 32 Rating: (0)
Suggestion To thank Quote Answer
This contribution was helpful to 1 thankful Users O_Moderator

|

Share this page:

Share this page on...

Follow us on