Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

Discrete Alarms

Created by: Memoli at: 4/7/2009 12:25 PM (4 Replies)

Rating (0)

Thanks 0

5 Entries

4/7/2009 12:25 PM	Rate (0)
Memoli Posts: 15 Rating: (0)	Hi Experts, We get 3 lines of each alarm in our HMI devices. Can enybody tell me what the meanings are of Text of alarm group "QGR" Report "on" We just want the alarm when its rised, not the acknowledge and gone.
Memoli Posts: 15 Rating: (0)
Suggestion To thank Quote Answer

4/7/2009 1:30 PM	Rate (0)
Manfred Gold Member Joined: 5/28/2008 Last visit: 12/8/2015 Posts: 901 Rating: (136)	Hello, QGR is a standard...you can configure your own texts... Alarm View > Properties > Column Texts > Acknowledgment group regards manfred

Suggestion To thank Quote Answer

4/7/2009 6:19 PM	Rate (0)
Memoli Posts: 15 Rating: (0)	Hi Manfred, What do i have to do so that only the alarm will shown that rises.
Memoli Posts: 15 Rating: (0)
Suggestion To thank Quote Answer

4/9/2009 7:33 PM	Rate (0)
Rodrigo N. Posts: 39 Rating: (0)	Hi, I had the same problem in my project, I would like to log only in the rise edge of the signal. The solution was togo up or down withthesignal send to the HMI in the program of the PLC,only in the rise edge of the original alarm signal, like this: ______ _______ original alarm signal: _____\| \|________\| \|________ _______________ signal send to HMI:_____\|\|_______________ This way the alarm is triggered only in the rise edge of the original signal. I hope you understand me Best regards, Rodrigo
Rodrigo N. Posts: 39 Rating: (0)
Suggestion To thank Quote Answer

4/14/2015 12:25 PM	Rate (0)
Min_Moderator Platinum Member Joined: 9/3/2014 Last visit: 3/13/2019 Posts: 4782 Rating: (123)	New question published by Aravinth is split to a separate thread with the subject Discrete alarm in TIA portal V13. Best regards Min_Moderator

Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on