Download project to OP17

Hello again.

I used cable from this topic OP17 to PC

When i connect OP17 to PC (ProTool) there was a messages:

first

"Establishing the serial connection at COM 1 with 9600 baud..."

and in the end of procedure

"The physical interface parameters you configured under PLC-Driver-Parameters are not allowed for the hardware version of the device currently connected"

So download failed.

Do i need to change anything in those parameters? look for attachment

I'm actually used baud  rate 9.6 because on maximum baud rate connection failed. 

In my case connection works but its ends by message I wrote earlier, and download failed. 

Connection ends by this message: 

" The physical interface parameters you configured under PLC-Driver-Parameters are not allowed for the hardware version of the device currently connected"

Hello Wizard

In Preferences of Download all settings is right:

serial, COM1 (COM1 is single port on my PC and baud rate on this port is 9600), baud rate 9600.

if i setting maximum baud rate (38400) only in this case communication failed.

Communication is established, but the problem is why download failed.

I'll be more specific.

I reset OP17 by pressing ESC+right+down. and now OP17 always in transfer mode. because its flash is empty. 

When i pressing "Download" a pop-up window appears "Establishing the connection to the OP" then "Transfering the loader" (it is connection, right?) and on OP signs increasing "----" symbolizing downloading (or other process of connection) then on half-second "Start the loader on the OP" and finally appears a message "The physical interface parameters you configured under PLC-Driver-Parameters are not allowed for the hardware version of the device currently connected"

The project i try to download is fully clean, its new. maybe need to set some settings?

I want to use OP17 with S7-300, MPI interface.

Look on settings in my 1st post of this topic in attachment.

OP17-PP

6AV3 617-1JC00-0AX1

Best regards,

Brusyc

Thanks for answer, i got it.

But problem still there. When using driver for S7-300 there is available profiles: MPI, DP, Standart and Universal. I use standart and universal on all baudrates and there is  the same issue like when i used setting MPI Profile.

i didn't find what interfaces supporting by OP17-PP. Please tell me 

Ok i find it.

Accordind this picture OP17-PP doesnt  support PLC's S7.

It is possible?