Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

Error 1003 on Siwarex WP231

Created by: BOBILLIER at: 4/2/2020 6:16 PM (1 Replies)

Rating (0)

Thanks 0

2 Entries

4/2/2020 6:16 PM	Rate (0)
BOBILLIER Posts: 14 Rating: (0)	Hi Today, i have try to configure stand alone WP231 with SIWATOOL7 after Upgrade firmware to 3.2.1. All seem work fine. All DR3 and other parameter modification are correctly modify. But i have one checksum error 1003 and Led Diag blinking Red. This error lock all action like Tare and Zero in Siwatool7 and write error in display panel. Finaly, i go back to 3.1.1 firmware to avoid this, and now all seem OK. Eric
BOBILLIER Posts: 14 Rating: (0)
Suggestion To thank Quote Answer

4/3/2020 5:06 PM	Rate (0)
Siwarexi Gold Expert Joined: 1/4/2007 Last visit: 11/21/2023 Posts: 1071 Rating: (165)	Hello BOBILLIER, Take a look to the attached file to the page 2, point „8.“, please. After a firmware-update, when you have the error 1003 (= „Checksum error“), then you have to do: - Send all data OR - load factory settings Best regards Siwarexi Attachment FAQS_WP2xx_firmware_update_EN.pdf (61 Downloads)

Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on