Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

Error - PCS 7

Created by: jimshad at: 1/29/2013 8:57 PM (2 Replies)

Rating (0)

Thanks 0

3 Entries

1/29/2013 8:57 PM	Rate (0)
jimshad Posts: 30 Rating: (0)	Hi... 7 simatic stations are used in our multi project. In one of the station, It was not allowed to make any changes in the hardware configuration. Error was" Open (257:9) The project contains objects of the software package PDM which cannot be edited because the soft ware package is not installed or exists is an earlier vsersion" and follows HW cofig (1230:2016) "No changes can be made in this station". All the stations consists of PA devices, and all I could do changes in the hardware configuration except the said station. So I installed SIMATIC PDM and after that I able to made changes in the hardaware configuration. But I can not access the PA devices through SIMATIC PDM. Error is " No authorisation for SIMATIC PDM single point/basic available" Please help me in this regard Best Regards Jimshad Ahamed
jimshad Posts: 30 Rating: (0)
Suggestion To thank Quote Answer

1/29/2013 9:14 PM	Rate (0)
UMENCHO Diamond Member Joined: 3/21/2006 Last visit: 12/2/2024 Posts: 10229 Rating: (1181)	From where did you install PDM?

Suggestion To thank Quote Answer

1/30/2013 8:49 AM	Rate (0)
chandu_38 Posts: 23 Rating: (5)	hi Which PDM version you have installed ?
chandu_38 Posts: 23 Rating: (5)	Last edited by: Chandrasekhar at: 1/30/2013 8:53 AM
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on