Error while compilating safety program

chat

Hello,

If had the same. The "solution" was very simple. Close Simatic Manager and start up again. After that you can compile the safety again.

I think this problem arises when you don't have used for more than 1 hourthe safety program. Then the program logged out and don't asked for it in some situations.

chat

Hello,

If had the same. The "solution" was very simple. Close Simatic Manager and start up again. After that you can compile the safety again.

I think this problem arises when you don't have used for more than 1 hourthe safety program. Then the program logged out and don't asked for it in some situations.

Jepp!

Restarting SM worked fine for me as well.
Thanks!

Thank you so much that i encountered the same issue and it almost spent the whole night to solve it.It works well after i re-launch simatic manager.

thanks,again and again!

 Even though I haven't found an answer, I am glad that at least someone else is running into the exact same thing...years ago.

Yanik

We have the same problem, but with FB1642...  That is not even present in the program.

The problem seems to be with Distributed Safety V5.4, we compile exactly the same program with V5.3 and everything is fine.

I don't see any Hotfixe available yet... Let me know if you find a solution!

Regards, Yanik

I had sam problem with Siemens FB80 F_SUM_1 for Fault Evalulation. 

Switching OFF and ON Step 7 did not worked for me.

I realized when you switch back address priority instead of symbolic priority everything is working fine and safety can be compiled without problem.

 The same here, just restarted Simatic Manager. Tks. 

chat

Hello,

If had the same. The "solution" was very simple. Close Simatic Manager and start up again. After that you can compile the safety again.

I think this problem arises when you don't have used for more than 1 hourthe safety program. Then the program logged out and don't asked for it in some situations.