HNC100 firmware version 5.18

Hello to all.

my friends 

I must connect to HNC100.  I have WINPED 5.10 and i need a firmware version  5.18 to do it.

please help me to found it.

please help me 

Thanks in advance.

------------------------------------------------------------------------------------------
Split from Manual for controller bosch rexroth VT-HNC100 ...2X?.

Hello!

Perhaps you should try this link:

http://www.boschrexroth.com.hk/business_units/bri/en/products/xxx_old_content/i_hnc100/hnc-2X/software/index.jsp

... at the bottom of this page, there is a e-mail address, where to ask for earlier versions....

Have fun!

uel123.