Hotel rooms, 220 Logo 12/24RCE and KPT700 HMI panel

Ah,,ok, now I start to understand the issue..

I still not have buy the 7" panel, I was looking from the reseller:

http://www.automation24.com/control-systems/simatic-basic-panel-siemens-ktp700-basic-pn-6av2123-2gb03-0ax0-i102-1729-0.htm

I see now there is a Basic KPT700 panel, but how I said before, the limit of 128 Logo's for now are enough.

I also checked on my WinCC v.13 software and there no possibility to load the Confort panels, only the all Basic panels.

I have to check how to configure the all 4 available connection for communicate with the 31 Logo! of each connection.

Thanks again for the help.

ixo65

When you write, your HMI can be max. 4 connections, then you have a basic panel.
This means that the HMI can communicate with max. 4 LOGO!s.
In a LOGO! network project you can integrating max. 32 LOGO!s.
So is for your case at 128 LOGO!s end off all.

A comfort panel can 8 connections. Then you communicte with 256 LOGO!s.

That is the theory.

But whether the data traffic synonymous works, I can not guarantee you.
In my opinion no one in this forum will do that.

Ask for an offer to Siemens.

 Hi, please last help for clarify all..

On Logo! Soft Confort V.8.0 Im able to configure the network of one HMI panel + 31 Logo's ( this is the limits) See in attachment the project test connection.

As you said before, on my WinCC basic are working only 4 Connections, this 4 connection im able to set the IP address to 4 LOGO!s

You write that in LOGO network project i can integrating max 32 LOGO ( as my project demo) for a total of 128 LOGO!s

32 Logo network X 4 connection= 128 LOGO!s, correct?

In the theory this 32 LOGO!s network project I have to connect ALL in ONE winCC Connection, but there I'm NOT able to connect or find how to configure this 32 LOGO!s in one connection.

Please can someone make me a winCC project example how to connect 31 LOGO!s network on one WinCC connection port?

Thanks again

ok thanks again

Where I can post this issue for getting WinCC support?