Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

How do I determine if Axis properties are ready to use?

Created by: o0yuming0o at: 12/23/2023 2:18 AM (2 Replies)

Rating (0)

Thanks 0

3 Entries

12/23/2023 2:18 AM	Rate (0)
o0yuming0o Advanced Member Joined: 3/30/2014 Last visit: 11/19/2024 Posts: 93 Rating: (3)	Such as "the Axis. PositioningState. Homed" this state, device after power on it will by "NO" into "YES", but it is a process. Whether any of the Axis properties can be used to indicate that other properties are in the correct state and can be used.

Suggestion To thank Quote Answer

12/23/2023 1:08 PM	Rate (0)
Davinator Gold Member Joined: 1/4/2013 Last visit: 12/3/2024 Posts: 1132 Rating: (102)	You can wait the .control property. Before it I think you should ignore all the other properties.
	Searching for Siemens used/new equipments ? Take a look here : https://www.ravettiautomation.com
Suggestion To thank Quote Answer

12/30/2023 9:28 AM	Rate (0)
Technology Team Platinum Expert Joined: 10/11/2006 Last visit: 12/3/2024 Posts: 5954 Rating: (819)	Which requirements have to be fulfilled before a technology object can be enabled via "MC_Power"? https://support.industry.siemens.com/cs/ww/en/view/109750297
	With best regards, Technology Team Application consulting and pre sales support for SINAMICS, SIMATIC Technology, SIMOTION, SIMOTICS and MOTION CONNECT
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on