Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

how start all SLM (6 pcs.) at the same time???

Created by: _oleksandr_ at: 8/11/2019 1:14 PM (1 Replies)

Rating (0)

Thanks 0

2 Entries

8/11/2019 1:14 PM	Rate (0)
_oleksandr_ Bronze Member Joined: 4/2/2016 Last visit: 7/13/2022 Posts: 413 Rating: (6)	tam1 Starting one slm at a time is very dangerous in this case. you should use only one CU in this case and it should ensure that the on command is given at a time. when you use one CU and some SLM (up to 4) of course you can start all SLM at the same time... BUT if you have a lot of power and you are not enough 4 pcs, SLM, eg. if you use CU 320 - 2 pcd. and SLM - 6 pcs. (circuit attached) how to be then??? how start all SLM (6 pcs.) at the same time??? ------------------------------------------------------------------------------------------ Split from sinamics SLM 12 pulse .
	Last edited by: Jen_Moderator at: 08/12/2019 07:00:02 New subject after splitting Last edited by: _oleksandr_ at: 09/20/2019 10:46:13
Suggestion To thank

8/12/2019 7:02 AM	Rate (0)
Jen_Moderator Moderator Joined: 6/19/2017 Last visit: 3/31/2023 Posts: 6704 Rating: (130)	Closed cause question posted twice. The second thread with the subject S120 SLM 12-pulse parallel connection is published within the conference SINAMICS. Best regards Jen_Moderator
	My Forum is the place to personalize your profile, track your topics, and maintain content that interests you. Best regards Jen_Moderator
Suggestion To thank

|

Share this page:

Share this page on...

Related topics by keywords:

SINAMICS_S

Follow us on