Skip to Content

support.automation.siemens.com | Technical Forum | Tuesday, March 18, 2025 12:28:19 AM

Print

How to Monitor the Motor Current & Temperature and other data's On SIMOCODE.

Created by: S7naga at: 12/9/2019 7:16 AM (2 Replies)

Rating (1)

Thanks 2

3 Entries

12/9/2019 7:16 AM	Rate (0)
S7naga Regular Member Joined: 12/28/2010 Last visit: 9/1/2022 Posts: 17 Rating: (0)	Hello Expert, In my new project, Our client requested to use a SIMOCODE module (PNIO) interface with S7 1500 CPU to monitor the motor feedback such as current, Volt, temperature & etc., and Start-stop the motor functionality. I haven't found any example in the forum. I request to share knowledge.

Suggestion To thank Quote Answer

12/16/2019 12:31 PM	Rate (1)
Mr. SIRIUS Bronze-Expert Joined: 5/17/2010 Last visit: 3/4/2025 Posts: 226 Rating: (28)	Hi S7naga, Depending on the Basic Type (1, 2 or 3) you configure at TIA portal for SIMOCODE pro V you will get a different size of cyclic process image. This always includes 16 binary information (bits) and up to 9 WORDs for analog values. The assignment of bits and analog values at process image is done at SIMOCODE parameterization (outputs -> cyclic send data) - see attached screenshot. If these analog values are not enough another way would be acyclic reading of data records (RDREC) which should not be used with high update rate. With best regards, Michael Attachment cyclic_send_data.png (324 Downloads)
	------------------------------------------------------------------------------------------------ Hilfreich? Über eine Bewertung des Posts würde ich mich freuen! :) Helpful? Would be great to get a rating on my post by you! THANKS! ;)
Suggestion To thank Quote Answer
This contribution was helpful to 2 thankful Users PISCEAN 2010 S7naga

1/3/2020 7:00 AM	Rate (0)
S7naga Regular Member Joined: 12/28/2010 Last visit: 9/1/2022 Posts: 17 Rating: (0)	Mr. SIRIUS, Thanks for your replied and information. Mr. SIRIUS Hi S7naga, Depending on the Basic Type (1, 2 or 3) you configure at TIA portal for SIMOCODE pro V you will get a different size of cyclic process image. This always includes 16 binary information (bits) and up to 9 WORDs for analog values. The assignment of bits and analog values at process image is done at SIMOCODE parameterization (outputs -> cyclic send data) - see attached screenshot. If these analog values are not enough another way would be acyclic reading of data records (RDREC) which should not be used with high update rate. With best regards, Michael

Suggestion To thank Quote Answer