Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

HSP Installation

Created by: Jonesee at: 11/28/2014 1:17 PM (5 Replies)

Rating (0)

Thanks 3

6 Entries

11/28/2014 1:17 PM	Rate (0)
Jonesee Advanced Member Joined: 11/17/2009 Last visit: 11/17/2024 Posts: 24 Rating: (3)	Hi, I am trying to install the HSP Firmware V4.7 devices support package for Portal V13 Update 6 (V13HSP01.isp13). The procedure requires that Portal is closed during the installation and after closing the installation continues. However, I get then get the message: "The support package can only be installed if the TIA Portal is being operated with administrator priviledges. The TIA Portal can now be started again." with a Finish or Cancel. I have tried re-starting Portal before and after the installation without success. I have also ran the security controller before and after. I am logged into Windows 7 Professional as an administrator user. Can anyone help?

Suggestion To thank Quote Answer

11/28/2014 10:19 PM	Rate (0)
William_B Posts: 5225 Rating: (1196)	Hi there. Try this.. Right click on the ICON that starts the program. From the selection list that pops up, ask for "Run as Administrator". The current Windows version does not always run a program in administration mode. It is a security feature M$ hopes will counter some of the unauthorised (malware) programs. ..I was under the impression that Update 6 for TIA13 already contains all the hardware that can be included into the Hardware Catelog. I must be wrong.. which hardware are you in need to include? Greetings. w
William_B Posts: 5225 Rating: (1196)
Suggestion To thank Quote Answer
This contribution was helpful to 1 thankful Users prasad h.

11/29/2014 10:31 PM	Rate (0)
Jonesee Advanced Member Joined: 11/17/2009 Last visit: 11/17/2024 Posts: 24 Rating: (3)	What a brilliant suggestion. And even better it solved the problem The HSP was needed to open a sample file for Sinamics inverter configuration. The base install appeared not to include all of the inverter types and firmware versions? Thanks for your help.

Suggestion To thank Quote Answer
This contribution was helpful to 1 thankful Users William_B

11/30/2014 7:30 AM	Rate (0)
William_B Posts: 5225 Rating: (1196)	Jonesee What a brilliant suggestion. And even better it solved the problem The HSP was needed to open a sample file for Sinamics inverter configuration. The base install appeared not to include all of the inverter types and firmware versions? Thanks for your help. Hi. If you have what you need now, then that is good news. Thank you for writing back and providing some helpful feedback. ..so the update does not contain all the hardware deffinitions.. hmmmm..
William_B Posts: 5225 Rating: (1196)
Suggestion To thank Quote Answer
This contribution was helpful to 1 thankful Users avarfolo

6/20/2016 5:33 PM	Rate (0)
Min_Moderator Platinum Member Joined: 9/3/2014 Last visit: 3/13/2019 Posts: 4766 Rating: (122)	New question published by AhsanA is split to a separate thread with the subject Missing Software for HSP. Best regards Min_Moderator

Suggestion To thank Quote Answer

5/26/2017 8:10 AM	Rate (0)
Min_Moderator Platinum Member Joined: 9/3/2014 Last visit: 3/13/2019 Posts: 4766 Rating: (122)	New question published by aalo is split to a separate thread with the subject Can't open project, new HSP needed. Best regards Min_Moderator

Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on