Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

initial values in load memory

Created by: JL at: 1/7/2006 2:22 PM (3 Replies)

Rating (0)

Thanks 0

4 Entries

1/7/2006 2:22 PM	Rate (0)
JL Posts: 3 Rating: (0)	Since we have problems with systems that constantly loads the initial values from the db's that we use for recepie and timer presets so have i tryed to use the sfc 83 and 84 and store a copy of the data in unlinked DB´s. But then looking online of the unlinked DB's after i have done a write to them from the user program so is the actual values updated correct but the initial values are still the same as then they where created. So i guess that then we get the problem that causes my "user DB's" to load their initial values so will the same happens with my unlinked backup DB's ? I'm also trying to be able to force the system to load inital values so i could test these backup functions, but on my desk so does it seems impossible to have the system to load the initial values. Memory reset will not fix this, how should i do ? Now using a 313C V2.0.11FW
JL Posts: 3 Rating: (0)
Suggestion To thank Quote Answer

1/7/2006 3:08 PM	Rate (0)
miami Platinum Expert Joined: 8/31/2005 Last visit: 11/13/2024 Posts: 2198 Rating: (328)	[quote user="JL"] I'm also trying to be able to force the system to load inital values so i could test these backup functions, but on my desk so does it seems impossible to have the system to load the initial values. Memory reset will not fix this, how should i do ? Now using a 313C V2.0.11FW When you want to start a CPU3xx with the initial values in a DB and not with the actual (saved orremanent) data I use this trick: Remove the MMC -> CPU will stop -> switch off Power supply -> insert MMC again -> switch on ----> now the CPU used the initial values data of the DBs

Suggestion To thank Quote Answer

1/7/2006 4:18 PM	Rate (0)
JL Posts: 3 Rating: (0)	No, they are still the actual values on my system, any other suggestions ?
JL Posts: 3 Rating: (0)
Suggestion To thank Quote Answer

1/20/2006 5:41 PM	Rate (0)
miami Platinum Expert Joined: 8/31/2005 Last visit: 11/13/2024 Posts: 2198 Rating: (328)	Did you remove the MMC while the CPU is in RUN? This forces a memory reset/clearence.

Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on